Question 450 After receiving the ticket, a senior technician asks: A new workstation needs high random I/O and has an available PCIe-connected M.2 socket; the old SATA SSD saturates the SATA link. Which observation provides the best confirmation? Both drives use magnetic platters but the faster model rotates at 7200 RPM The drive connector and controller specifications show SAS disks unsupported by the SATA-only host Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe Explanation Correct Answer C:Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe, consistent with a nvme ssd over pcie for high-throughput storage. Incorrect Answers A:Both drives use magnetic platters but the faster model rotates at 7200 RPM, consistent with a hdd spindle speed influences rotational latency. B:The drive connector and controller specifications show SAS disks unsupported by the SATA-only host, consistent with a sas drive requires compatible controller interface. D:The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe, consistent with a m.2 physical form factor is not the storage protocol.
Question 451 A client has a thin laptop with a SATA M.2 slot only and buys an NVMe-only M.2 drive that fits mechanically but is invisible. Which additional observation would most strongly corroborate the suspected cause? Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss The drive connector and controller specifications show SAS disks unsupported by the SATA-only host The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe Explanation Correct Answer D:The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe, consistent with a m.2 physical form factor is not the storage protocol. Incorrect Answers A:Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe, consistent with a nvme ssd over pcie for high-throughput storage. B:The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss, consistent with a raid 5 single-parity tolerance. C:The drive connector and controller specifications show SAS disks unsupported by the SATA-only host, consistent with a sas drive requires compatible controller interface.
Question 452 To avoid replacing the wrong part, a technician reviews the issue: A workstation uses a 5400 RPM mechanical disk and a user complains about slow seeks compared with a supported 7200 RPM disk. Which verification is the most discriminating? The configuration writes the same blocks to both drives and can run degraded with one member Both drives use magnetic platters but the faster model rotates at 7200 RPM Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe The array stripes data across disks without mirrored or parity redundancy Explanation Correct Answer B:Both drives use magnetic platters but the faster model rotates at 7200 RPM, consistent with a hdd spindle speed influences rotational latency. Incorrect Answers A:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks. C:Benchmarking shows the existing drive capped near SATA throughput while the board supports NVMe, consistent with a nvme ssd over pcie for high-throughput storage. D:The array stripes data across disks without mirrored or parity redundancy, consistent with a raid 0 provides no disk fault tolerance.
Question 453 A technician has a tentative diagnosis for this incident: Two disks are striped for speed, and the loss of one member makes the entire volume unavailable. Which test result would support it most directly? The storage specification requires tolerance of any two failed members in the parity set The configuration writes the same blocks to both drives and can run degraded with one member The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss The array stripes data across disks without mirrored or parity redundancy Explanation Correct Answer D:The array stripes data across disks without mirrored or parity redundancy, consistent with a raid 0 provides no disk fault tolerance. Incorrect Answers A:The storage specification requires tolerance of any two failed members in the parity set, consistent with a raid 6 dual-parity design. B:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks. C:The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss, consistent with a raid 5 single-parity tolerance.
Question 454 A two-drive workstation must keep identical copies of data on both drives and tolerate one drive failure. Which evidence distinguishes the likely cause from other issues in the same technical area? The storage specification requires tolerance of any two failed members in the parity set The array stripes data across disks without mirrored or parity redundancy The configuration writes the same blocks to both drives and can run degraded with one member The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss Explanation Correct Answer C:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks. Incorrect Answers A:The storage specification requires tolerance of any two failed members in the parity set, consistent with a raid 6 dual-parity design. B:The array stripes data across disks without mirrored or parity redundancy, consistent with a raid 0 provides no disk fault tolerance. D:The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss, consistent with a raid 5 single-parity tolerance.
Question 455 Before repairing this fault, the service desk wants reproducible evidence: A storage box has four equal drives in a RAID 5 array and one disk fails; reads continue but another failure during rebuild threatens data. Which finding is most relevant? The array stripes data across disks without mirrored or parity redundancy The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss The storage specification requires tolerance of any two failed members in the parity set The configuration writes the same blocks to both drives and can run degraded with one member Explanation Correct Answer B:The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss, consistent with a raid 5 single-parity tolerance. Incorrect Answers A:The array stripes data across disks without mirrored or parity redundancy, consistent with a raid 0 provides no disk fault tolerance. C:The storage specification requires tolerance of any two failed members in the parity set, consistent with a raid 6 dual-parity design. D:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks.
Question 456 After receiving the ticket, a senior technician asks: An archival server needs a parity array that can survive two simultaneous disk failures without a mirrored copy of every drive. Which observation provides the best confirmation? The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss The storage specification requires tolerance of any two failed members in the parity set The storage layout combines mirrors with striping across pairs rather than simple parity The configuration writes the same blocks to both drives and can run degraded with one member Explanation Correct Answer B:The storage specification requires tolerance of any two failed members in the parity set, consistent with a raid 6 dual-parity design. Incorrect Answers A:The array can operate degraded after one disk failure but cannot tolerate a second concurrent member loss, consistent with a raid 5 single-parity tolerance. C:The storage layout combines mirrors with striping across pairs rather than simple parity, consistent with a raid 10 striped mirrors. D:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks.
Question 457 A database server requires both mirrored redundancy and performance from a stripe built over multiple mirrored pairs. Which additional observation would most strongly corroborate the suspected cause? The storage layout combines mirrors with striping across pairs rather than simple parity The configuration writes the same blocks to both drives and can run degraded with one member The storage specification requires tolerance of any two failed members in the parity set The drive connector and controller specifications show SAS disks unsupported by the SATA-only host Explanation Correct Answer A:The storage layout combines mirrors with striping across pairs rather than simple parity, consistent with a raid 10 striped mirrors. Incorrect Answers B:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks. C:The storage specification requires tolerance of any two failed members in the parity set, consistent with a raid 6 dual-parity design. D:The drive connector and controller specifications show SAS disks unsupported by the SATA-only host, consistent with a sas drive requires compatible controller interface.
Question 458 To avoid replacing the wrong part, a technician reviews the issue: A business storage backplane uses enterprise SAS disks, while an off-the-shelf SATA-only controller cannot communicate with them. Which verification is the most discriminating? The configuration writes the same blocks to both drives and can run degraded with one member The drive connector and controller specifications show SAS disks unsupported by the SATA-only host The storage layout combines mirrors with striping across pairs rather than simple parity The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe Explanation Correct Answer B:The drive connector and controller specifications show SAS disks unsupported by the SATA-only host, consistent with a sas drive requires compatible controller interface. Incorrect Answers A:The configuration writes the same blocks to both drives and can run degraded with one member, consistent with a raid 1 mirrored disks. C:The storage layout combines mirrors with striping across pairs rather than simple parity, consistent with a raid 10 striped mirrors. D:The device manual specifies SATA-based M.2 storage while the replacement requires PCIe NVMe, consistent with a m.2 physical form factor is not the storage protocol.
Question 459 A technician has a tentative diagnosis for this incident: A compact mini-tower chassis accepts only mini-ITX boards, but a technician orders a full-sized ATX motherboard. Which test result would support it most directly? The chassis standoff and I/O layout fit mini-ITX and not the dimensions of full ATX The recovery prompt appears after TPM identity changes even though the encrypted disk is intact The motherboard's CPU support list excludes the chosen processor and the physical socket differs The chassis front-panel cable and board manual identify different header pinouts Explanation Correct Answer A:The chassis standoff and I/O layout fit mini-ITX and not the dimensions of full ATX, consistent with a motherboard form-factor mismatch. Incorrect Answers B:The recovery prompt appears after TPM identity changes even though the encrypted disk is intact, consistent with a tpm-bound key protection after motherboard swap. C:The motherboard's CPU support list excludes the chosen processor and the physical socket differs, consistent with a cpu socket and platform incompatibility. D:The chassis front-panel cable and board manual identify different header pinouts, consistent with a motherboard internal header connection mismatch.
Question 460 A desktop motherboard supports an Intel socket but the purchaser selects an AMD CPU with a different socket package. Which evidence distinguishes the likely cause from other issues in the same technical area? The motherboard's CPU support list excludes the chosen processor and the physical socket differs Firmware logs indicate a secure-boot signature or policy validation failure The recovery prompt appears after TPM identity changes even though the encrypted disk is intact The chassis standoff and I/O layout fit mini-ITX and not the dimensions of full ATX Explanation Correct Answer A:The motherboard's CPU support list excludes the chosen processor and the physical socket differs, consistent with a cpu socket and platform incompatibility. Incorrect Answers B:Firmware logs indicate a secure-boot signature or policy validation failure, consistent with an uefi secure boot rejects untrusted bootloader. C:The recovery prompt appears after TPM identity changes even though the encrypted disk is intact, consistent with a tpm-bound key protection after motherboard swap. D:The chassis standoff and I/O layout fit mini-ITX and not the dimensions of full ATX, consistent with a motherboard form-factor mismatch.