Question 930 A maintenance window is available for the following problem: A department's laser printer shows black specks scattered over clean white areas on multiple test pages after a toner spill. Which intervention is most appropriate? Restore the correct network route and approved printer protocol access Replace the identified compatible toner and run vendor calibration if required Perform approved cleaning and inspect cartridge, drum and transfer components Clear or service the finisher's staple path using approved procedures Explanation Correct Answer C:Speckling persists across different documents and visible loose toner is present in the device, consistent with a loose toner or contaminated laser print path. Incorrect Answers A:A local test page succeeds while authorized clients cannot reach the printer's configured IP or print service, consistent with a printer network reachability or allowed ports blocked. B:The device's toner status and controlled test pages show one color missing across all clients, consistent with a depleted color toner cartridge. D:The printer can produce un-stapled output while the stapling unit shows an obstruction, consistent with a stapler finisher mechanism jam.
Question 931 A user asks what may happen if the issue is not correctly handled: A desktop turns off abruptly during 3D rendering but runs office applications, and a power monitor shows the graphics workload exceeding the current supply's reliable output. Which outcome is best supported? A thermal trip correlates with temperature limits rather than a measured total-power shortfall Memory errors can crash applications without showing the specified power-demand overrun Changing only the display resolution cannot make an undersized supply deliver more power A display-driver reset usually does not produce a complete power-off at peak measured PSU load Explanation Correct Answer C:The shutdown coincides with combined CPU and GPU power demand rather than rising component temperature, consistent with a power supply capacity inadequate under load. Incorrect Answers A:CPU temperature reaches the thermal protection threshold before shutdown even when PSU power is sufficient, consistent with a cpu thermal shutdown under sustained compute. B:Memory stress tests fail with aggressive timings while PSU readings stay inside the rated capacity, consistent with an unstable memory xmp profile. D:The graphics driver records a reset event and the system continues running instead of abruptly losing power, consistent with a gpu graphics driver timeout.
Question 932 A PC sounds a repeated memory-related POST beep pattern after being moved, and the display never shows firmware setup. Which prediction follows from this particular failure mode? Changing only the display resolution cannot make an undersized supply deliver more power A display cable replacement cannot correct processor initialization failure before video startup A blank monitor is not proof that the computer itself failed to start Replacing a monitor will not resolve firmware reporting failed memory initialization Explanation Correct Answer D:The motherboard's documented beep code identifies RAM and inspection finds a DIMM latch not fully closed, consistent with a memory module unseated after transport. Incorrect Answers A:The shutdown coincides with combined CPU and GPU power demand rather than rising component temperature, consistent with a power supply capacity inadequate under load. B:The motherboard beep code and CPU support list indicate the processor requires a newer supported BIOS, consistent with an unsupported cpu or firmware initialization failure. C:The active video signal comes from the discrete card while the monitor is connected to an inactive motherboard output, consistent with a display output routed to wrong graphics port.
Question 933 When documenting this incident, a technician notes: A workstation slows and then powers off during extended compiling, with CPU temperature reaching the hardware protection limit. Which limitation is most directly relevant? Reinstalling the OS cannot preserve firmware clock power during a disconnected state Changing only the display resolution cannot make an undersized supply deliver more power Adding RAM will not correct a processor that is overheating Higher memory speed does not overcome a CPU held back by thermal protection Explanation Correct Answer C:The heatsink fan is stopped and temperature climbs rapidly before the slowdown, consistent with a cpu thermal throttling from failed cooling. Incorrect Answers A:Firmware settings reset only when wall power is removed and the RTC cell voltage measures low, consistent with a depleted cmos/rtc battery. B:The shutdown coincides with combined CPU and GPU power demand rather than rising component temperature, consistent with a power supply capacity inadequate under load. D:CPU temperature and clock monitoring show thermal limits reached while the fan remains at low RPM, consistent with a firmware cooling policy causing cpu throttling.
Question 934 A powered-off desktop repeatedly loses the date and firmware boot order between unplugged sessions, although it starts normally after configuration. Which risk or behavior would be expected if a superficially attractive but incorrect workaround were used? Replacing storage drives cannot remove airflow restrictions causing thermal shutdowns Adding RAM will not correct a processor that is overheating Reinstalling the OS cannot preserve firmware clock power during a disconnected state Higher memory speed does not overcome a CPU held back by thermal protection Explanation Correct Answer C:Firmware settings reset only when wall power is removed and the RTC cell voltage measures low, consistent with a depleted cmos/rtc battery. Incorrect Answers A:Fan speed rises while internal temperature continues increasing and dust blocks the intake, consistent with an overheating caused by obstructed airflow. B:The heatsink fan is stopped and temperature climbs rapidly before the slowdown, consistent with a cpu thermal throttling from failed cooling. D:CPU temperature and clock monitoring show thermal limits reached while the fan remains at low RPM, consistent with a firmware cooling policy causing cpu throttling.
Question 935 A user asks what may happen if the issue is not correctly handled: An aging tower sometimes refuses to start and the motherboard contains electrolytic capacitors with bulging tops and residue. Which outcome is best supported? A PSU can fail during short power spikes even if average usage appears acceptable Failed power regulation components can cause unstable startup and may damage nearby parts Operating-system repair cannot start hardware that receives no stable supply output A memory profile stable with one DIMM is not guaranteed stable with multiple modules Explanation Correct Answer B:A visual inspection with AC power disconnected finds swollen or leaking capacitors near the voltage regulators, consistent with a damaged motherboard capacitors. Incorrect Answers A:Restarts correlate with GPU load transients while thermals remain within safe limits, consistent with a power supply transient response or headroom shortfall. C:A known-good power cord and wall outlet deliver power but the PSU fails safe output tests, consistent with a failed or disconnected power supply. D:A memory diagnostic fails only with the aggressive shared timing profile enabled, consistent with an unstable combined ram profile.
Question 936 A desktop has no fan spin and no standby LED after a storm, although the wall socket tests good with another device. Which prediction follows from this particular failure mode? A PSU can fail during short power spikes even if average usage appears acceptable Operating-system repair cannot start hardware that receives no stable supply output Replacing storage drives cannot remove airflow restrictions causing thermal shutdowns Changing only the display resolution cannot make an undersized supply deliver more power Explanation Correct Answer B:A known-good power cord and wall outlet deliver power but the PSU fails safe output tests, consistent with a failed or disconnected power supply. Incorrect Answers A:Restarts correlate with GPU load transients while thermals remain within safe limits, consistent with a power supply transient response or headroom shortfall. C:Fan speed rises while internal temperature continues increasing and dust blocks the intake, consistent with an overheating caused by obstructed airflow. D:The shutdown coincides with combined CPU and GPU power demand rather than rising component temperature, consistent with a power supply capacity inadequate under load.
Question 937 When documenting this incident, a technician notes: A PC restarts only when a new graphics card enters its highest performance state, and a wattmeter shows brief load spikes above the supply's rating. Which limitation is most directly relevant? Changing only the display resolution cannot make an undersized supply deliver more power Operating-system repair cannot start hardware that receives no stable supply output A blank monitor is not proof that the computer itself failed to start A PSU can fail during short power spikes even if average usage appears acceptable Explanation Correct Answer D:Restarts correlate with GPU load transients while thermals remain within safe limits, consistent with a power supply transient response or headroom shortfall. Incorrect Answers A:The shutdown coincides with combined CPU and GPU power demand rather than rising component temperature, consistent with a power supply capacity inadequate under load. B:A known-good power cord and wall outlet deliver power but the PSU fails safe output tests, consistent with a failed or disconnected power supply. C:The active video signal comes from the discrete card while the monitor is connected to an inactive motherboard output, consistent with a display output routed to wrong graphics port.
Question 938 A home computer displays random blue screens after a new memory kit was added; each stick works alone but both fail together at overclocked timing. Which risk or behavior would be expected if a superficially attractive but incorrect workaround were used? A memory profile stable with one DIMM is not guaranteed stable with multiple modules A display cable replacement cannot correct processor initialization failure before video startup Higher memory speed does not overcome a CPU held back by thermal protection A PSU can fail during short power spikes even if average usage appears acceptable Explanation Correct Answer A:A memory diagnostic fails only with the aggressive shared timing profile enabled, consistent with an unstable combined ram profile. Incorrect Answers B:The motherboard beep code and CPU support list indicate the processor requires a newer supported BIOS, consistent with an unsupported cpu or firmware initialization failure. C:CPU temperature and clock monitoring show thermal limits reached while the fan remains at low RPM, consistent with a firmware cooling policy causing cpu throttling. D:Restarts correlate with GPU load transients while thermals remain within safe limits, consistent with a power supply transient response or headroom shortfall.
Question 939 In a post-repair discussion, the team reviews: A small desktop repeatedly powers off on hot days; its intake vents and fan blades are covered with thick dust. Which technical implication should be highlighted? Reinstalling the OS cannot preserve firmware clock power during a disconnected state Replacing storage drives cannot remove airflow restrictions causing thermal shutdowns Higher memory speed does not overcome a CPU held back by thermal protection Additional software cooling policies cannot repair a physically failing fan bearing Explanation Correct Answer B:Fan speed rises while internal temperature continues increasing and dust blocks the intake, consistent with an overheating caused by obstructed airflow. Incorrect Answers A:Firmware settings reset only when wall power is removed and the RTC cell voltage measures low, consistent with a depleted cmos/rtc battery. C:CPU temperature and clock monitoring show thermal limits reached while the fan remains at low RPM, consistent with a firmware cooling policy causing cpu throttling. D:The fan rotor wobbles or intermittently stalls and its RPM falls below the specified minimum, consistent with a failing fan bearing in cooling assembly.
Question 940 A server's fan makes a grinding sound and CPU temperatures climb even when the case filters are clean. Which technical consequence or limitation best explains why the problem matters? Replacing storage drives cannot remove airflow restrictions causing thermal shutdowns Higher memory speed does not overcome a CPU held back by thermal protection A display cable replacement cannot correct processor initialization failure before video startup Additional software cooling policies cannot repair a physically failing fan bearing Explanation Correct Answer D:The fan rotor wobbles or intermittently stalls and its RPM falls below the specified minimum, consistent with a failing fan bearing in cooling assembly. Incorrect Answers A:Fan speed rises while internal temperature continues increasing and dust blocks the intake, consistent with an overheating caused by obstructed airflow. B:CPU temperature and clock monitoring show thermal limits reached while the fan remains at low RPM, consistent with a firmware cooling policy causing cpu throttling. C:The motherboard beep code and CPU support list indicate the processor requires a newer supported BIOS, consistent with an unsupported cpu or firmware initialization failure.