Question 770 Two Ethernet ports repeatedly transition up and down when a damaged cable is flexed, causing short network outages. Which underlying component or configuration issue is most consistent with the evidence? Link flapping caused by physical cabling fault Copper link impairment from excessive cable length External 2.4 GHz radio-frequency interference Ethernet duplex mismatch Explanation Correct Answer A:Switch interface logs show repeated link-state transitions correlated with cable movement, consistent with a link flapping caused by physical cabling fault. Incorrect Answers B:Cable certification shows the run exceeds the supported channel length and has failing attenuation results, consistent with a copper link impairment from excessive cable length. C:Spectrum activity rises near the microwave and the problem disappears when it is off, consistent with an external 2.4 ghz radio-frequency interference. D:Interface counters show late collisions or FCS errors and duplex settings differ on link partners, consistent with an ethernet duplex mismatch.
Question 771 During a support incident, A long copper Ethernet run connects at a slower rate and produces CRC errors near the maximum cable-length limit. What is the most likely technical explanation? Link flapping caused by physical cabling fault Excessive route latency from indirect network path Ethernet duplex mismatch Copper link impairment from excessive cable length Explanation Correct Answer D:Cable certification shows the run exceeds the supported channel length and has failing attenuation results, consistent with a copper link impairment from excessive cable length. Incorrect Answers A:Switch interface logs show repeated link-state transitions correlated with cable movement, consistent with a link flapping caused by physical cabling fault. B:Round-trip time rises at the remote gateway despite low local LAN latency, consistent with an excessive route latency from indirect network path. C:Interface counters show late collisions or FCS errors and duplex settings differ on link partners, consistent with an ethernet duplex mismatch.
Question 772 An office reports slow one-way file transfers after replacing a managed switch; one port is forced full duplex while its peer is half duplex. Which failure mode should the technician prioritize? Incorrect switch access VLAN assignment Copper link impairment from excessive cable length WAN congestion without VoIP quality-of-service prioritization Ethernet duplex mismatch Explanation Correct Answer D:Interface counters show late collisions or FCS errors and duplex settings differ on link partners, consistent with an ethernet duplex mismatch. Incorrect Answers A:The switch port's configured VLAN ID does not match the intended user network, consistent with an incorrect switch access vlan assignment. B:Cable certification shows the run exceeds the supported channel length and has failing attenuation results, consistent with a copper link impairment from excessive cable length. C:Packet drops and voice degradation coincide with saturated outbound bandwidth, consistent with a wan congestion without voip quality-of-service prioritization.
Question 773 A help-desk ticket states: A VPN user's connection is reachable but suffers long page-load delays; traceroute and monitoring show an unusually long path through distant gateways. Which diagnosis is best supported rather than simply possible? Copper link impairment from excessive cable length Excessive route latency from indirect network path Enterprise Wi-Fi certificate validation failure Incorrect default route to external subnets Explanation Correct Answer B:Round-trip time rises at the remote gateway despite low local LAN latency, consistent with an excessive route latency from indirect network path. Incorrect Answers A:Cable certification shows the run exceeds the supported channel length and has failing attenuation results, consistent with a copper link impairment from excessive cable length. C:802.1X logs show the client rejects the RADIUS server certificate chain, consistent with an enterprise wi-fi certificate validation failure. D:The first-hop gateway cannot be ARPed on the local network but other hosts use a different router address, consistent with an incorrect default route to external subnets.
Question 774 When comparing several hypotheses, a technician observes: An employee can join the office Wi-Fi but every attempt to access the protected network fails with a certificate trust error. Which condition best fits? Excessive route latency from indirect network path Enterprise Wi-Fi certificate validation failure Incorrect switch access VLAN assignment DHCP relay or VLAN reachability failure Explanation Correct Answer B:802.1X logs show the client rejects the RADIUS server certificate chain, consistent with an enterprise wi-fi certificate validation failure. Incorrect Answers A:Round-trip time rises at the remote gateway despite low local LAN latency, consistent with an excessive route latency from indirect network path. C:The switch port's configured VLAN ID does not match the intended user network, consistent with an incorrect switch access vlan assignment. D:Lease requests from the affected VLAN do not arrive at the central DHCP service, consistent with a dhcp relay or vlan reachability failure.
Question 775 A technician investigates this device problem: A laptop can communicate with devices on its access VLAN but not with a server on another floor after its switch port was moved to a new VLAN. Which diagnosis best explains the observed pattern? Ethernet duplex mismatch DHCP relay or VLAN reachability failure Incorrect default route to external subnets Incorrect switch access VLAN assignment Explanation Correct Answer D:The switch port's configured VLAN ID does not match the intended user network, consistent with an incorrect switch access vlan assignment. Incorrect Answers A:Interface counters show late collisions or FCS errors and duplex settings differ on link partners, consistent with an ethernet duplex mismatch. B:Lease requests from the affected VLAN do not arrive at the central DHCP service, consistent with a dhcp relay or vlan reachability failure. C:The first-hop gateway cannot be ARPed on the local network but other hosts use a different router address, consistent with an incorrect default route to external subnets.
Question 776 A workstation has a correct static IP and subnet mask but no route to external networks because the configured default router IP is wrong. Which underlying component or configuration issue is most consistent with the evidence? IPv6 router advertisement or default-route loss Excessive route latency from indirect network path Incorrect switch access VLAN assignment Incorrect default route to external subnets Explanation Correct Answer D:The first-hop gateway cannot be ARPed on the local network but other hosts use a different router address, consistent with an incorrect default route to external subnets. Incorrect Answers A:The hosts have no learned global router even though their network interfaces show link-local IPv6, consistent with an ipv6 router advertisement or default-route loss. B:Round-trip time rises at the remote gateway despite low local LAN latency, consistent with an excessive route latency from indirect network path. C:The switch port's configured VLAN ID does not match the intended user network, consistent with an incorrect switch access vlan assignment.
Question 777 During a support incident, Several IPv6 clients can reach neighbors with link-local addresses but have no valid route to a public IPv6 website. What is the most likely technical explanation? Unstable fixed wireless line-of-sight alignment Incorrect default route to external subnets Excessive route latency from indirect network path IPv6 router advertisement or default-route loss Explanation Correct Answer D:The hosts have no learned global router even though their network interfaces show link-local IPv6, consistent with an ipv6 router advertisement or default-route loss. Incorrect Answers A:The ISP radio signal and error rate worsen as the outdoor mount moves in wind, consistent with an unstable fixed wireless line-of-sight alignment. B:The first-hop gateway cannot be ARPed on the local network but other hosts use a different router address, consistent with an incorrect default route to external subnets. C:Round-trip time rises at the remote gateway despite low local LAN latency, consistent with an excessive route latency from indirect network path.
Question 778 A small firm's network works each morning but loses WAN access each evening when its fixed wireless antenna shifts in high wind. Which failure mode should the technician prioritize? Incorrect default route to external subnets WAN congestion without VoIP quality-of-service prioritization IPv6 router advertisement or default-route loss Unstable fixed wireless line-of-sight alignment Explanation Correct Answer D:The ISP radio signal and error rate worsen as the outdoor mount moves in wind, consistent with an unstable fixed wireless line-of-sight alignment. Incorrect Answers A:The first-hop gateway cannot be ARPed on the local network but other hosts use a different router address, consistent with an incorrect default route to external subnets. B:Packet drops and voice degradation coincide with saturated outbound bandwidth, consistent with a wan congestion without voip quality-of-service prioritization. C:The hosts have no learned global router even though their network interfaces show link-local IPv6, consistent with an ipv6 router advertisement or default-route loss.
Question 779 A help-desk ticket states: A VoIP deployment loses voice packets while file transfers saturate the uplink during office backups. Which diagnosis is best supported rather than simply possible? Unstable fixed wireless line-of-sight alignment Packet jitter harms real-time VoIP Ethernet duplex mismatch WAN congestion without VoIP quality-of-service prioritization Explanation Correct Answer D:Packet drops and voice degradation coincide with saturated outbound bandwidth, consistent with a wan congestion without voip quality-of-service prioritization. Incorrect Answers A:The ISP radio signal and error rate worsen as the outdoor mount moves in wind, consistent with an unstable fixed wireless line-of-sight alignment. B:RTP monitoring shows large variations in packet interarrival time rather than sustained congestion, consistent with a packet jitter harms real-time voip. C:Interface counters show late collisions or FCS errors and duplex settings differ on link partners, consistent with an ethernet duplex mismatch.
Question 780 When comparing several hypotheses, a technician observes: A shared office printer jams repeatedly at the same feeder corner and its paper-size guides are set for a wider tray than the actual paper. Which condition best fits? Paper tray detection sensor not actuated Paper-feed guide misalignment Frozen print queue or spooler path Printer driver language mismatch Explanation Correct Answer B:Sheets skew into the pickup path and the paper guides do not touch the loaded stack correctly, consistent with a paper-feed guide misalignment. Incorrect Answers A:Removing and reseating the tray changes the sensor state while the tray's paper guides are correct, consistent with a paper tray detection sensor not actuated. C:The local device prints independently while the server's queued jobs remain stuck, consistent with a frozen print queue or spooler path. D:The server sends a page-description format unsupported by the target printer model, consistent with a printer driver language mismatch.